LAVERDAMANIA

DIY #13

Mikuni RS36 set up- Laverda 1000 et 1200
(Click on the pictures to enlarge)

The Mikuni carbs are more precise and accurate than the old original ones. One of the consequences is that the jets are usually smaller.

Reaching the main jets.
Removing the main jet
Removing the float bowl to reach some components, notably the pilot jets.
Surely a good thing to replace the original screws by Allen ones. The correct size is 4X12mm.
Where the various jets are located
Setting the needle height. Remove the Allen screw, remove the needle and set it on the correct notch.

<<< Back